The M1003 Stopswitch is a simple inductive shaft speed monitoring device. The self-contained unit, which signals when the shaft has stopped rotating. It can be used for process control, motion detection and stopped shaft indication. An inductive sensing device located in the nose of the M100 enclosure will detect a metal target. This target can be an existing bolt head or device attached to a shaft. The M1003 Stopswitch requires no calibration and provides an output when the shaft has stopped rotating.
4B Braime M1003 Stopswitch
M1003 Stopswitch
Description
Additional information
Brand |
---|
GET A PRICE
To receive a proposal, please send your application to [email protected] and specify the required positions and company details.
Specification
| ||
Specification | Value | |
Supply Voltage: | 24 to 240 VAC/VDC | |
Supply Fusing: | Supply to be fused at 500mA maximum | |
Switching Capacity: | 50mA maximum | |
Saturation Voltage: | 5.5 Volts maximum (output on) | |
Leakage Current: | 1.0 mA maximum (output off) | |
Ambient Temperature: | 5°F (-15°C) to +122°F (+50°C) | |
Output State: | FET | |
Sensing Range: | 6 mm (15/64”) maximum on ferrous metal at 77°F (25°C) | |
Input Pulse Range: | 20 to 3,600 pulses per minute (PPM) maximum | |
Start-Up Delay: | 4 seconds | |
Trip Point: | zero speed | |
Enclosure: | Nylon - ISO threaded 18 mm by 1.0 mm pitch | |
Relative Humidity: | 90% RH | |
LED Indicators: | Blue - Target Sensed, Green - Rotation Detected | |
Connections: | 2 wire, 3m long cable. | |
Protection: | IP66 |